Li-Cu-Li Composite Foil (0.1mm Li on Two sides of Cu Foil), 100g/pack (80 mm W x 6m L) - LCL2S80

99.9% Lithium, 99.99% Copper

• Structure: Li (0.1 mm) + Cu (12um) + Li (0.1 mm)
• Size: 80mm Width x 6000mm L x 0.21 mm Thickness (Li layer width 80mm; Cu layer width 100mm)
• Weight:100g/roll 

Packed a steel container filled under dry room (RF < 2%)

• Clean the surface of the lithium foil using a nylon brush/stainless steel scalpel until a shiny silvery surface appears (inside an argon glovebox)

• Shipments of lithium foil are described as “UN 1415, Lithium, 4.3, PG I"
  All shipments are Hazard Class 4.3 and require “Dangerous when wet” labels
  Sea Class 4.3 (IMDG)
  Road, Rail Class 4.3 11a (RID/ADR)

• Package must be opened and stored inside a glove box with Argon Gas and moisture less than 8 ppm and O2 less than 2 PPM. Never use N2 gases in glovebox!!!

• Operation and Storage: Lithium is very active in the air, please carefully read the SDS carefully.
• Lithium foil may be oxidized during handling and storage. if you find any oxidation on the surface of the Li-chip, please use sandpaper to remove it before using it.
• Li foil may have a passivation layer, from our customer experience, removing the passivation layer will increase your battery capacity
• If the Li metal is stored in mineral oil, please refer to this guide on How to clean mineral oil off Lithium metal using anhydrous Toluene
• The lithium foil was packed in the dry room with < 10 PPM H2O. Therefore, a slight increase of O2 PPM level might be seen in the glove box when the can is opened. Please keep purging the glove box with ultra-high purity Ar until the required O2 PPM level is reached.
• No return or refund for misusing or wrong storage which causes lithium foil oxidation.

• Why Can not sell in a small package? A: Small package will cost more from a manufacturer
• Why Li-Chip so expensive? A: Because of shipping regulations from packing to shipping will cost 90% or more.

53L Vacuum Chamber SVC-6050

Glovebox